JVC Nivico 5340 vintage metal HORN SPEAKERS, alnico magnets

$50.00

One pair heavy/high quality horns from high end JVC floor speakers. Made in Japan probably in the early 1970's.

Excellent sound quality. They are about 16" deep, about 13 3/4" wide, and 3 1/4" tall. Quite heavy because the cast metal frames are about 3/16" thick... Marked "Victor" (marked over) Squawker SK2135B 16 ohm 15W Japan. The horizontal piece in the center of the horns is made of masonite board and it got banged up on both horns- on one a little worse than the other. Should not really effect the sound at all but if you wanted to replace it doesn't look difficult- the horns are made of two pieces screwed together. The board looks to be only about 7 inches or so long.

I got about 13.8 ohms each on my meter. These were designed as midrange horns but seem to work well for higher frequencies too.

The 5340 was rated 20-20kHz, 80 watts, 8 ohms. Each speaker featured a large metal horn, two tweeters, and a woofer. See my other listings for the other parts including the grills. This definitely was one of JVC's flagship products.

Send your zip code for ship cost- should be between $9.95 and $19.95 if you are in the continental USA (Nov. 2012).

Sponsors

Copyright © 2024 EdsGoodStuff. Powered by EdsGoodStuff LVC