For Sale: Tested and working classic stereo receiver.
Excellent sound quality on both channels. No hum or distortion. All controls except the Balance control working correctly- for some reason turning balance has no effect. The sound outputed to the speakers is definitely in stereo.
Has good FM stereo reception, good stereo indicator light, good VU, all backlights working well. Does not show much wear- scratch on top of wood case is the worst of it. Has all the standard receiver features plus pre-out/main in jacks, low filter, high cut, loudness, and phono input.
Has schematic diagram inlcluded in envelope attached to the bottom by factory. Stickers on the side say "240V" but internally the transformer jumpers have been changed to run at standard US 120 volt.
Info from the web:
Specifications
Tuning range: FM, MW
Power output: 39 watts per channel into 8Ω (stereo)
Frequency response: 20Hz to 40kHz
Total harmonic distortion: 0.8%
Damping factor: 24
Input sensitivity: 2.5mV (MM), 150mV (line)
Signal to noise ratio: 70dB (MM), 80dB (line)
Channel separation: 45dB (MM), 50dB (line)
Output: 150mV (line), 30mV (DIN)
Speaker load impedance: 4Ω to 16Ω
Semiconductors: 1 x FET, 4 x IC, 45 x transistors, 27 x diodes, 2 x zener diodes
Dimensions: 462 x 147 x 335mm
Weight: 13.1kg
Year: 1968
Email for additional/higher resolution photos.
Email your zip code for shipping cost - should be between $14.99 and $39.99 if you are in the continental USA (March 2015).
